Instructions for Installing the MBA Dash Dress Kit

1) Assemble the required tools 

2) Remove the 6 screws that hold the lower dash panels 

3) Set all the dash knobs to the off position. This will make it easier to align the MBA knobs during the installation

4)Using a flat blade screwdriver or similar device pry off the stock dash knobs. Make sure you tape the blade to avoid scratching the dash panel. Put tape over the tip of the screwdriver to avoid damaging the dash panel.

5) Clean the surfaces with a good cleaner but not one that is strong enough to damage the plastic surface

6) Next dry fit all the MBA plates to make sure there is no interference and they align properly

7) Apply the double sided tape to the back of the MBA panel or the dash surface. The choice is yours depending on which way you are more comfortable. after you have installed the tape remove the backing from the other side of the tape 

8) Carefully set the MBA panels in place. Make sure your alignment is right on because once the tape makes contact it will be hard to get it off without screwing up the tape

9) After the MBA panels are installed its time to place the knobs on the shafts. Refer to your notes so you can install them in the proper position. Tighten the set screws and try turning the knobs.

10) If everything is working correctly then you can put the dash panels back in place.